Knowledgebase
Dapol Sound Decoders - Volumes CVs
Posted by Fiona F. on 17 May 2021 10:40 AM

All Dapol sound decoders are supposed to have the main engine sounds set at full volume.

Should you find the volume too low, then there is a way of amending this, as per Dapol's sound engineer, see below:

Therefore, the only way to turn them up would be to turn the entire project up via CV266 (value 64 as delivered)  and then turn down the individual sounds if they become too loud for the user. The user should listen out for distortion when turning up the volume and if distortion occurs reduce the volume until the sound is clean again. To assist with this I've also attached a list of the volume CVs for Zimo decoders.



Attachments 
 
 zimo volume cvs_dapol sounds.pdf (124.56 KB)
(2 vote(s))
Helpful
Not helpful