Knowledgebase
Dapol O Gauge Terrier Stops moving whilst sound continues
Posted by Andy F. on 14 October 2015 12:49 PM

Applicable to 1st batch/release of Terriers with factory fitted sound only.

Under specific circumstances and combinations of DCC Controller this caused the decoder to halt the motor, whilst continuing operation of the sound as normal.

Early Terriers were fitted with incorrect capacitors on the suppression board.  Therefore they need to be swapped over by us (DCC Supplies)

Existing capacitors should be removed and new values should be 0.1uF Fitted on the 'board side' and 1000pF fitted motor side.

(0 vote(s))
Helpful
Not helpful

Comments (0)